Help
- Menus and Settings
- Account
- Profile
- Target setting
- Remaining battery
- Information zone setting
- Smart device notifications
- Wake-up alarm
- Sleep setting
- Error display
- Application Settings
- Email Settings
- Event markers
- Switch between real-time and history
- Explanation of Meter Screen
- Reload and Share buttons
- Workout History
- Workout Graphs (PS-600 exclusive feature)
- Workout Category
- Statistical Data
- How to understand the resting pulse chart
- PS-100 LED display and vibration
- PS-500 LED display and vibration
- PS-500 Measurement method
Heart rate
Detecting heart rate.
Vibrates five times when your hear rate cannot be detected after one minute.
Heart rate detection is complete.
Quickly vibrates two times.
The device cannot detect your heart rate. To detect your heart rate, the device needs to be worn snugly around your wrist to collect more accurate heart rate data. This may cause a slight impression on the wrist. Adjust the band for the comfort and performance you choose. Make sure the Pulsense device does not touch your ulna bone.
The device cannot detect your heart rate. To detect your heart rate, the device needs to be worn snugly around your wrist to collect more accurate heart rate data. This may cause a slight impression on the wrist. Adjust the band for the comfort and performance you choose. Make sure the Pulsense device does not touch your ulna bone. Warm your wrist or fingertips if they are cold.
Target zone
When tapped, it indicates that your current heart rate is below the zone.
Your heart rate has fallen out of the zone during exercise.
You are exercising at an intensity where your current heart rate is between 0 - 24% of your maximum.
You are exercising at an intensity where your current heart rate is between 25 - 49% of your maximum.
You are exercising at an intensity where your current heart rate is between 50 - 69% of your maximum.
You are exercising at an intensity where your current heart rate is between 70 - 100% of your maximum.
Your heart rate exceeds the target zone.
Your heart rate exceeded the zone.
Vibrates five times.
Your heart rate has returned to the target zone.
Vibrates five times.
Battery
Battery charging.
Battery is fully charged.
An error occurred while charging.
The remaining battery level on the device is low.
Bluetooth
Bluetooth pairing is complete.
Device has been unpaired.
Alert
Firmware update complete.
You've left airplain mode.
This is an alert and the LED display as shown in the figure on the left repeats six times. The alerts depend on your settings. You can set up a wake-up alarm, or the device can alert you when you receive an email, call, or calendar notification.
Airplane mode
1 Remove the device from the cradle and wait.
2 Continuously tap the upper part of device 7–8 times.
3 After the LEDs blink in the pattern shown below, the LEDs will turn off and the device will be in airplane mode.
The device is in Airplane Mode.
To unlock airplane mode, tap the top part of the device repeated.
The LEDs will light up as shown in the figure on the left. Tap until the LEDs stop lighting up. Now the device is ready for use. It will begin detecting your pulse.